What should be the gain of an amplifier?

What should be the gain of an amplifier?

What should be the gain of an amplifier to have no voltage loss or gain? Clarification: An amplifier is usually used to increase the output voltage of a signal. Since gain = output voltage/input voltage and the input voltage is equal to the output voltage, the gain of the amplifier must be 1.

Where does the Q point of a Class C amplifier position?

Position of Q-point : Below the cut off region of operation. 3. Operating cycle : Circuit operates for less than 180˚ of input signal.

What is the efficiency of Class C amplifier?

In a class-C amplifier, less than 50% of the input signal is used (conduction angle Θ < 180°). Distortion is high and practical use requires a tuned circuit as load. Efficiency can reach 80% in radio-frequency applications.

What should be the gain of an amplifier to have no voltage loss or gain?

What should be the gain of an amplifier to have no voltage loss or gain? Explanation: An amplifier is usually used to increase the output voltage of a signal. Since gain = output voltage/input voltage and the input voltage is equal to the output voltage, the gain of the amplifier must be 1. 9.

In which configuration current gain of an amplifier is low?

amplifier
The configuration in which the current gain of the transistor amplifier is lower is a common base.

What are Class C amplifiers used for?

➢ The Class C amplifier is used in the applications like RF oscillators, RF amplifier, FM transmitters, Booster amplifiers, High frequency repeaters and Tuned amplifiers. ➢ The main advantage of the Class C amplifier is, it has a Lowest physical size for a given power output.

What is Class C power amplifiers?

When the collector current flows for less than half cycle of the input signal, the power amplifier is known as class C power amplifier. The efficiency of class C amplifier is high while linearity is poor. The conduction angle for class C is less than 180o.

What is 20dB gain?

dB and Voltage gain (20dB = 10x) When talking about voltage, 6dB represents a ratio of two to one or a doubling of voltage. 20dB would represent a ratio of ten to one for voltage – so 20 dB would be 10 times the voltage. A 40dB voltage gain would be 100 times the voltage.

What is gain equal to?

The technical term for an amplifier’s output/input magnitude ratio is gain. As a ratio of equal units (power out / power in, voltage out / voltage in, or current out / current in), gain is naturally a unitless measurement. Mathematically, gain is symbolized by the capital letter “A”.

What is a Class C power amplifier?

Class C power amplifier. Class C power amplifier is a type of amplifier where the active element (transistor) conduct for less than one half cycle of the input signal. Less than one half cycle means the conduction angle is less than 180° and its typical value is 80° to 120°.

What are the disadvantages of Class C amplifiers?

Class C amplifiers present higher efficiencies than class A, B or AB. However, their conduction angle is very low between 0° and 180°, meaning that they conduct only a fraction of the signal. This fact leads to a poor linearity of the amplifier, both voltage and current outputs are very distorted because they present a high number of harmonics.

What is the conduction angle of a Class C amplifier?

Less than one half cycle means the conduction angle is less than 180° and its typical value is 80° to 120°. The reduced conduction angle improves the efficiency to a great extend but causes a lot of distortion. Theoretical maximum efficiency of a Class C amplifier is around 90%.

How does a Class C amplifier work in an RF transmitter?

The Class C amplifiers used in RF transmitters usually are operating at a single fixed carrier frequency. In such applications, the distortion is controlled by a tuned load on the amplifiers. The input signal is applied to switch the active device (transistor) and so the current is directed to flow through a tuned load.