What cable do floppy drives use?
Floppy Disk Drive Cable The cable uses a 34-pin IDC connector [requiring a 34-pin device header], and a 34-pin flat ribbon cable [IDC Definition]. The connector size differ between the two drive types, with the 5.25″ drives requiring a larger connector.
What is the function of floppy drive connector?
Today, if any floppy drive is in the computer it would connects to “Drive A:” and the end cable connected to the motherboard. The floppy channel, FDD header, or floppy connection is where the floppy drive connects to the computer motherboard….Floppy cable.
Pin | Description |
---|---|
PIN 33 | Ground |
PIN 34 | Ground |
What do you call the cable that attaches the motherboard to the floppy drive?
Browse Encyclopedia. A. R. A thin, flat, multiconductor cable that is widely used for internal peripheral connections in electronic systems. In a PC, a 34-wire ribbon connects the floppy drive (if present) to the motherboard.
Where is the twist on the floppy drive cable located?
You will also notice that there is an odd “twist” in the floppy cable, located between the two pairs of connectors intended for the floppy drives.
Do floppy drives use IDE?
Floppy drives don’t use a normal IDE (PATA) connection; they use a special 34-pin connector. If your motherboard does not have this connector then you’ll need to get a USB floppy drive instead.
What is a floppy disk weakness?
Disadvantages of a floppy disk : Floppies can get affected by heat. Small storage capacity. Also limited capacity. Many new computers don’t have any floppy disk drive. Data can be erased if the disk comes into contact with a magnetic field side.
What is Rainbow wire?
RAINBOW WIRE® Stranded copper conductors, insulated with color coded PVC (type THW) and bonded together with green insulated ground, configured flat and parallel with no overall jacket.
What will happen if you plug a floppy drive cable in backward?
Plugging a floppy cable in backwards was harmless (with a couple of exceptions–more on that in a minute), but the drives wouldn’t work. It just sent all the drive signals to ground. Another method was to leave out a pin on the motherboard and on the floppy cable.