How do you adjust Shimano chain tension?

How do you adjust Shimano chain tension?

Locate the derailleur screw that has the letter “B” printed below it. Insert your screwdriver into the B-tension screw. Rotate the derailleur screw counterclockwise to decrease the tension of the chain. Turn the B-tension screw clockwise to tighten the chain around the teeth of the rear sprocket.

How do you adjust tension on a derailleur?

Adjust the cable tension Use the barrel adjuster to fine-tune its position. Turning the adjuster anticlockwise increases tension on the cable, bringing the derailleur closer to the wheel. Clockwise decreases the tension, moving it back towards the frame.

What is the B tension adjustment screw?

B-Tension Screw – The b-tension screw is used to adjust the distance between the top pulley of the rear derailleur and the cassette or freewheel. When the b-screw is screwed in, it pushes against a lip on the derailleur hanger. In consequence, the derailleur “decompresses” and “descends”.

How do you fix a chain tension on a bike?

To change the tension loosen one of the axle-nuts and move the wheel forward or backward slightly and snug it up again. Then, loosen the opposite axle-nut, adjust and tighten, making sure the wheel remains centered in the frame. Re-check tension. A chain tensioner can make the process easier.

Can the spring tension on the slide topper be adjusted?

The spring tension on the slide topper can be adjusted but you must do it carefully because there is considerable energy in the stored spring if it were to get away from you. The following link will take you to a document that describes the proper, and safe, procedure for adjusting the slidetopper tension and replacing fabric.

How do I adjust the slide topper awning?

Adjusting slide topper awnings is fairly simple. Usually takes 2 people. The roller has a spring in it. Move slide out. Look for the pin hole near end of roller. Put a cotter pin in the hole. Make sure it will not fall out. Remove end cap or mount.

How do Slide toppers work?

Slide toppers are nothing more than a spring loaded roller mechanism with a fabric material that will wind up when the slide is retracted and unroll to cover the top of the slide as when it is extended. Any debris laying on top will simply fall off when the topper rolls up. Eventually the fabric will wear and require replacement.

What are the effects of wind on the slide topper?

Also, springs can lose tension over time and the effects of wind billowing can be noticed as the material flaps around in the wind when the slide is extended. The spring tension on the slide topper can be adjusted but you must do it carefully because there is considerable energy in the stored spring if it were to get away from you.