How do I use my Linksys WRT54G as a repeater?

How do I use my Linksys WRT54G as a repeater?

Linksys Wireless-G Router (WRT54G)…Configuring an Access Point as a wireless repeater

  1. Access the router’s web-based setup page.
  2. When the router’s web-based setup page opens, click Status then click Wireless.
  3. Take note of the MAC Address.
  4. Connect a computer to the access point.
  5. Assign a static IP address on the computer.

How old is WRT54G?

The original WRT54G was first released in December 2002. It has a 4+1 port network switch (the Internet/WAN port is part of the same internal network switch, but on a different VLAN).

How do I reset my Linksys RE6400?

Press and hold the Reset button of your Linksys RE6400 for 10 seconds to reset the range extender to its factory defaults.

What’s new with the Linksys WRT54G?

The Linksys WRT54G also performs as a DHCP server with a powerful firewall to protect your computers against intruders and most known Internet attacks. The router function ties it all together, letting your whole network share high-speed Cable or DSL Internet connection. See what’s new with the Linksys WRT Wireless Router!

What is the difference between WRT54G and WTR54GS?

WTR54GS. The Linksys WTR54GS is a confusingly named derivative of the WRT54G. It is a compact wireless travel router with SpeedBooster support that has only one LAN and one WAN Fast Ethernet interfaces, but has two wireless interfaces. The WTR54GS has the ability to make an unencrypted wireless connection on one interface,…

How many network switches does the WRT54GC have?

It has a 4+1 port network switch (the Internet/WAN port is part of the same internal network switch, but on a different VLAN ). The devices have two removable antennas connected through Reverse Polarity TNC connectors. The WRT54GC router is an exception and has an internal antenna with optional external antenna.

How do I upgrade the firmware on my WRT54G-TM?

T-Mobile Edition WRT54GS V3.0 (Renamed WRT54G-TM). It is possible to upgrade to third-party firmware via JTAG or by replacing the CFS and uploading a new firmware over TFTP. Instructions for the CFS/TFTP method can be found easily on the Internet, and other third-party firmware can be easily applied afterwards.