How do I know if my Chevy truck has keyless entry?

How do I know if my Chevy truck has keyless entry?

Typically the sticker is located on the driver side dashboard, inside the glove box, beneath the spare tire cover or under the trunk hood. Look across the sticker for the RPO code for keyless entry.

How many miles will a 2006 Chevy Silverado last?

With regular maintenance and conscientious use, a good model year of the Chevrolet Silverado can last between 200,000 to 300,000 miles or more. That means you can easily get 10 to 20 years of reliable service from a Silverado truck with proper maintenance.

How do you reset the ECU on a Chevy Silverado?

Slide the cable off of the battery and set it aside. Turn the headlight switch to the on position to drain the ecu of any remaining power. Wait at least 10 minutes, then turn it back to the off position. Replace the negative battery cable by reversing the previous steps.

Does my car have a factory keyless entry system?

The easiest way to determine if your vehicle has a factory keyless entry system is to try to put it in programming mode to accept a new transmitter. If it goes into programming mode, it has factory keyless entry.

How do I program my Silverado key fob?

On your Chevy key fob, press and hold the “Unlock” and “Lock” buttons at the same time. Do this until you hear the door locks engage and disengage again. This is an indicator that the key fob has been programmed successfully. Re-insert the newly programmed key into the ignition in the “On” position.

Can you roll windows down with key fob Chevy?

In addition to folding in your mirrors, your key fob also has the ability to roll your windows down. Navigate to the “remote lock, unlock, and start” menu in the vehicle settings. Scroll down to “remote window operation” and turn the feature on. Hold the unlock button down to roll your windows down.

How do you reset the computer on a 2005 Chevy Silverado?

How to Reset a 2005 Chevrolet Computer

  1. Pop open the hood of your Chevy and locate the negative battery terminal. On this terminal is a clamp that has a nut attached to it.
  2. Wait 30 minutes then put the negative battery clamp back onto the negative side of the battery. Tighten the nut with the end wrench.