Do you have to have a fence around a pool in South Carolina?

Do you have to have a fence around a pool in South Carolina?

The IPMC requires swimming pools, hot tubs, and spas containing water more than 24 inches in depth to be completely surrounded by a fence or barrier not less 48 inches in height above the finished ground level measured on the side of the barrier away from the pool (IPMC code section 303).

What is code for fence around pool?

Fence height and clearance requirements: Installed pool fences should be at least 48-inches high from finished ground level, as measured along the outside of the fence and should have no more than a two-inch gap from the bottom of the fence to the ground. The fence or barrier must not be climbable.

Do I need a fence for a 3 foot pool?

Although your might have decided to go with the above-ground pool, the fencing requirements for the property are still the same. In most cases, you must have a fence of at least four feet tall. As long as the body of water (either in-ground or above ground) is at least 18 inches deep, you do need to install a fence.

How far does a fence have to be from a pool?

Pool Compliance Regulations NSW Explanation No1 – Pool Fence As a pool owner, you must understand that your pool fence should be at least 1200mm from ground level. Additionally, there should be no more than 100mm gap between the fence bottom and the ground.

Do I need a permit for an above ground pool in South Carolina?

Prefabricated portable and above ground swimming pools 48” in depth or less and less than 3500 gallons and not permanently attached to electrical or plumbing systems do not require a permit. They do require a building permit before installation.

Is it illegal to not have a fence around a pool?

Fencing – In almost all cases, public-use pools are required to have some kind of fencing around the pool. States, cities, and counties usually specify exactly what is required of these fences in terms of material, spacing, gates, locks, and more.

How far does a pool need to be from a fence?

The top of a fence or wall used as a barrier needs to be a minimum of 48 inches above the exterior side of the barrier. The access gate opens away from the swimming pool. There will be a clear zone of at least 20 inches between the barrier and swimming pool.

Is it illegal to not have a fence around your pool?

How deep can a pool be without a fence?

How Deep Can A Pool Be Without A Fence? In most areas, a pool can be less than 18″ and not need a fence or barrier surrounding it.

How do you build a boundary fence pool compliant?

In NSW, a pool fence must:

  1. be at least 1.2m high (as measured from the finished ground level)
  2. not leave a gap at the bottom bigger than 10cm from the finished ground level.
  3. if a boundary fence is part of the pool fence, the barrier must be 1.8m high.
  4. not have gaps of more than 10cm between any vertical bars in the fence.

How much clearance do I need for a pool fence?

The top of the barrier must be at least 48-inches above grade measured on the exterior side of the fence opposite the pool The maximum allowable vertical clearance between grade and the bottom of the barrier shall be 2-inches measured on the exterior side of the fence opposite the pool

What are the rules for an outdoor swimming pool?

An outdoor swimming pool, including an in-ground, above ground or on-ground pool, hot tub or spa shall be surrounded by a barrier which shall comply with the chapter 3 of the 2018 International Swimming Pool and Spa Code.

Which pools are exempt from ASTM F 1346 barriers?

Spas, hot tubs, and pools with a safety cover complying with ASTM F 1346 shall be exempt from the barrier requirements listed above.

What is the maximum distance between vertical members of a fence?

Where the barrier is composed of horizontal and vertical members and the distance between the tops of the horizontal members is 45-inches or more, spacing between vertical members shall not exceed 4-inches. Where there are decorative cutouts within vertical members, spacing within the cutouts shall not exceed 1¾-inches in width