Why is my front headlight not working?

Why is my front headlight not working?

The likely cause is a fuse, headlight relay, headlight switch, dimmer switch or a wiring fault. About the only cause that is an easy fix is a blown fuse. Consult your owner’s manual to locate the main fuse for the headlight circuit and replace that fuse with one having the same amp rating.

Is there a recall on the Hyundai Sonata?

Hyundai Motor America (Hyundai) is recalling certain 2017-2018 Sonata, 2016-2018 Sonata Hybrid, 2018-2020 Accent, and 2016-2017 Azera vehicles. The trunk latch may become damaged, preventing the opening of the trunk from the inside.

What causes headlight to keep blowing?

This is due to spikes of high voltage jumping through the system which in turn blow the bulb filaments and/or headlight fuses. You can perform a simple test to check if the voltage regulator is faulty, however, you’ll need another person to help you rev the engine whilst you take a multimeter reading.

What are some of the Hyundai Sonata headlights problems?

If the headlights on your Hyundai Sonata are malfunctioning, they should be fixed immediately. Faulty headlights can obscure road vision and lead to car accidents and serious injury. Loose electrical connections, burned out bulbs and popped fuses create most headlight problems, and all three have a quick fix.

How do you fix a bad headlight?

Faulty headlights can obscure road vision and lead to car accidents and serious injury. Loose electrical connections, burned out bulbs and popped fuses create most headlight problems, and all three have a quick fix. Turn off the engine. Allow it to cool down before checking the connections. Open the hood.

How do I change the light bulbs on my headlight assembly?

Disconnect the power cord from the bulb base at the back of the assembly. Push the bulb spring on the assembly to remove the light bulb. Pull the old bulb out and place the new bulb in. The low-beam lights use H7 bulbs. The high-beam lights use H1 bulbs. Reattach the bulb spring and reconnect the power cord. Refasten the plastic covers.